wood boat planks
The planks may be mechanically connected to each other with copper rivets, bent over iron nails, screws or in modern boats with adhesives. often, steam bent wooden ribs are fitted inside the hull. strip planking is yet another type of wooden boat construction similar to carvel. it is a glued construction method which is very popular with. Shipwright louis sauzedde demonstrates his unique method for scarfing wood boat planks that allows him to work at a high speed with minimal effort.. Place the soaked wood plank onto the boat hull, following the curves of the hull. apply a hot iron to the plank as you bend it in place. the heat from the iron will help you mold the plank to the hull. clamp the plank into place at both ends and in the center. allow the plank to dry completely in place..
wood boat planks The next step is to “line-off” for planking, that is to determine where the plank edges will be, based on the determined number of planks for the boat. based on the number of planks per side, marks are made on the moulds are pre-determined positions. battens are then nailed below these marks, fore and aft of the moulds.. 2. clinker plywood boatbuilding manual by iain oughtred (wooden boat books, maine usa 1988) an all round handy book . 3. hartley's guide to boat building by rt hartley ( nautical services, sydney australia 1961 ) this is a bit of a unique book to australia and might be hard to get elsewhere...
